F1 Fast Buckle Velcro Strap x1 - The Velcro buckle/strap on the Scarpa F1 boots. These are sized in ranges and a bit different for left versus right.
F1 Power Strap x1 - The removable Velcro power strap (without a buckle) for the Scarpa F1. Be sure to order the correct size and left vs right.
F1 LT Fast Buckle Velcro Strap x1 - The Velcro buckle/strap on F1 LT boots. Please note the size and side you need. Women's straps come in blue while unisex straps are the stock orange color.
F1 LT Power Strap x1 - The removable Velcro power strap (without a buckle) for the Scarpa F1 LT. Be sure to order the correct size and left vs right.
Gea RS 2.0 Cuff Buckle - The upper cuff buckle for the Gea RS 2.0.
Gea RS 2.0 Instep Buckle - The middle buckle for the instep strap on the Gea RS 2.0.
Gea RS 2.0 Shell Buckle - The lowest buckle for the Gea RS 2.0 that sits on the tongue of the boot.
Maestrale 1.0 Instep Strap - The plastic strap across the instep of the first generation Maestrale. Be sure to order the correct size and left vs right.
Maestrale RS 2.0 Cuff Catch - Buckle catch for the topmost buckle on the Maestrale/Gea RS 2.0.
Maestrale RS 2.0 Cuff Buckle - The upper cuff buckle for the Maestrale or Gea RS 2.0.
Maestrale RS 2.0 Instep Buckle - The middle buckle for the instep strap on the RS 2.0 boots.
Maestrale RS 3.0 Instep Strap x1 - The plastic instep strap with a ladder-style set of teeth for the Maestrale/Gea RS 2.0 and 3.0. Be sure to order the correct size and left vs right.
Maestrale RS 2.0 Power Strap x1 - The velcro power strap for the Maestrale/Gea RS 2.0. Be sure to order the correct size and left vs right.
Maestrale RS 2.0 Wave Cable x1 - The cable that runs along the lower shell of the boot and is tightened by the Shell Buckle. Be sure to order the correct size.
Maestrale RS 2.0 Wave Cable Upper End Screw - The screw that secures the Wave Cable to the boot just below the Instep Buckle.
Maestrale RS 2.0 Wave Cable Upper Holder - The black plastic bit between the Wave Cable and the Upper End Screw.
Maestrale RS 2.0 Shell Buckle - The lowest buckle for the Maestrale RS 2.0 that sits on the tongue of the boot.
I have the Scarpa Rush boots (size 27.5), very similar to the Maestrale. I need a new instep buckle but I am not sure what size. Do you know? Thanks, Allen
Allen, measure the width of the instep strap, either 23 or 17mm wide. If 17mm , you can order either the grey or orange one, they are pretty much the same.
Answer this question:
3/25/2019
Question from
Gdn
I have a pair of Maestrale RSs and the upper (mid calf) buckle’s catch/ladder/rack broke off. Which of these parts will replace it?
We do not have any catches for the Maestrale. The one pictured is for an older Alien boot and wouldn't be a good substitute.
Answer this question:
3/24/2019
Question from
April
I have a pair of Scarpa Pegasus AT ski boots size 28. This buckle has failed on one of my boots- which size corresponds with my boot? Thanks for your reply!
April, Which buckle? The buckles listed as Maestrale 1.0 should work for you.
Answer this question:
3/14/2019
Question from
John willis
I have a pair of scarpa maestrale 28.5. Both instep straps have failed and I am looking for the parts. My shop has ordered them and after 2 weeks still hasn’t got them. I would like to have a spare set anyway. Please advise part number and availability
John, Which Maestrale do you have? We only have the parts for the Maestrale 1.0 ( pre 2017). THE Instep Strap we have here is quite different then the current model.
Answer this question:
2/13/2019
Question from
jake mills
I'm looking for the wire latch that flips up to go into walk mode and flips down for ski mode on the Maestrale 1.0 boot. Do you carry this piece?
Hi Jake, we have had those in the past, but haven't seen them in a minute. Not sure if any are left in the supply chain!
Answer this question:
11/26/2018
Question from
George Ciavola
Hi, I have an older pair of Scarpa Maestrale boots size 27 and I would like to purchase a instep strap set for them and I wondered which ones do I order from you?
The strap has the wire loop at the attached end like the picture above.
Hey Thomas! Looks like we're out of that specific power strap at the moment, but luckily the mounting pattern on that power strap is very simple and almost any power strap will bolt into it. You might have to get a bit creative with hardware in order to mount it, but yeah, most any power strap will bolt into it just fine.
Hey Thomas! The TLT7 Power Strap comes with hardware and is an AWESOME power strap! Find them in the drop-down menu here!
Answer this question:
10/26/2018
Question from
DaveSLC
I need to replace the instep strap on my Maestrale 1.0. They are a mens size 10. Which of the two straps should I order? The only markings on the boot are on the inside plastic cuff -DX260/280.
Hey Kyle! Nope, no Recco in these ones (yet). Once we have the Recco option we'll make a distinction in the drop-down menu.
Answer this question:
8/16/2018
Question from
william fenton
I have pair of maestrale mango AT boots (original type) I am having trouble finding replacement plastic grey hinges. there are four of them, two on each boot. Any idea where to find them, or how to fix broken hinge? Thank you.
Hey William! These are the hinges for the tongue, correct? If so it looks like we're out (and have been for some time actually) so unfortunately directing you back to Scarpa is the best I can do at this point.