Moving Dynafit bindings from one ski to another often requires a brake change to accommodate the new width. Brakes can also get damaged. Please note ► The Dynafit brakes listed below the line are priced individually so you will need two if switching skis or one if fixing damage. The brakes have a few millimeters of wiggle room, so a 100mm brake will work on a ski slightly over 100mm in underfoot width. If you're looking for brakes for a Dynafit Speed Radical or Speed Turn bindings, check out the Kreuzspitze Heel Brakes!
Low Tech Race 68mm x2 - Non-removable brakes for LTR 105 and 115 bindings
Low Tech Race 74mm x2 - Mid-size, non-removable brake for LTR 105 and 115 bindings.
Low Tech Race 80mm x2 - Largest brake option for LTR 105 and 115 bindings.
Superlite 75mm x2 - Removable TLT Superlite 2.0 brakes, in a 75mm width for skinny skis.
Superlite 90mm x2 - 90mm all-around version of the new cool Superlite 2.0 brakes.
Superlite 105mm x2 - The widest brake available for the Superlite 2.0, for those powder skis.
Blacklight 75mm x2 - Narrowest removable brake option for the Blacklight binding.
Blacklight 80mm x2 - Narrower removable brake for the Blacklight binding.
Blacklight 90mm x2 - Middle-of-the-road removable brake option for the Blacklight binding.
Blacklight 100mm x2 - Wider option for removable brakes on the Blacklight binding.
Blacklight 105mm x2 - Widest removable brakes for the Blacklight binding.
I need only the metal plate that sits on top of the stopper when mounted (it is seen at the bottom of picture 3). Do you sell this separately? If not, is it included if I buy the full stopper set?
Hey Alexander! This is the metal "H" clip that you are looking for, correct? If so, one h clip is included with each individual brake when purchased new.
Answer this question:
12/8/2018
Question from
John Greene
Hello, will your Beast 105mm work on my Beast 14 binding? Thanks.
Hey John! We haven't ever carried that binding, but as far as I know, they should work. I think the heel piece is the same between the various Beast bindings, so it should be fine.
Answer this question:
12/1/2018
Question from
Chris
Skis are 112 underfoot, Dynafit brake options are 105 or 120, can the 105 be bent to fit?
Hey Lee! Yes, both can be installed/removed after mounting.
Answer this question:
11/27/2018
Question from
Dave
So I'm not totally sure if I messed up or not. I have a set of dynamite TLT radical FT 2.0 bindings with 135mm brakes (that I picked up last spring for cheap), but the skis I want to put them on are voile v6 163s with a 96mm waist for my wife. Can I get brakes for these? Do you have them?
Hey Dave! We have more of those brakes on the way and they should be here soon-ish actually. I think the options are 90 or 105mm. Want me to put your email address down so you get a notification when they arrive?
Answer this question:
11/25/2018
Question from
A.D.
Hi, do you have any "Radical 2.0 90mm w/ Baseplate" stock incoming? And could I get on that email notification list if so? Thanks!
Johnno, There is some wiggle room on most brakes. The big thing is if the side wall is square at the top sheet there is less wiggle room. If the side wall tapers at all you should be fine.
Answer this question:
11/20/2018
Question from
Jed
I have the TLT Radical ST 2.0 135mm. I'd like to order the Radical ST 110mm, will this base plate/brake combo work with my current binding?
Hey Jed! That's a negative. It's very important that if you have the Radical 2.0, you stick with a 2.0 brake. The Radical and Radical 2.0 are different in terms of the hardware and there's not a whole lot of compatibility across the models. I think we should be getting more Radical 2.0 105mm brakes in stock soon. Let me know if you'd like me to put your email down on a notification list for when they show up and I can make it happen.
Answer this question:
11/4/2018
Question from
Ben J
Do you have any more 120 mm brakes for Radical 2.0 available for purchase?
Hey Tim! It's a decent amount wider than I'd like to see. You'll bash the brakes together while skinning and they'll catch while skiing steeps. Not ideal in those cases but if it's for mellow powder skiing then you might be able to get away with it. Ideally I'd like to see you on a 105mm brake.
I have the Dynafit TLT Radical FT Binding circa 2015, and need a new brake size for a narrower ski. (currently a 130mm brake) Will the Radical FT 110mm brake fit the current binding and new Moment Wildcat Tour 108?
Yes, those brakes should work well for your setup!
Answer this question:
10/11/2018
Question from
Max
I have a Dynafit TLT Speed Radical that came with no brakes. It is mounted on a 2014 K2 Backdrop, 112 at the sole. What do I need to put brakes on my binding?
Hi Max, unfortunately the Speed Radical binding does not allow for brakes to be added. You could potentially convert your Radical into a Radical ST by purchasing Radical ST brakes, heel turrets, and toe plates for the Radical ST but it can be a bit pricey to do so.
Answer this question:
10/5/2018
Question from
Chris
Will these work with the dynafit st binding (4 year old binding)? My wife is jumping up to a wider ski and her current brakes are too narrow. Thanks!
Hey Chris! There might be a few options. Will you either link a picture in the next comment or send me an email with a picture of the binding to make sure we're talking about the same thing? The reason I ask is because there are about a dozen bindings with the "ST" moniker and there were two or three in circulation at that point in time so it's important to make sure we're on the same page.
Hey Kris! Thanks for reaching out. Unfortunately about 80% of Dynafit's bindings in the past 8 years have had an "ST," "FT," or "Speed" designation so it's totally possible, though very difficult to assume here because not all bindings with the "FT" designation are created equal in terms of hardware compatibility. Could you send me a picture at help@skimo.co of the binding so we can eliminate any potential confusion?
Answer this question:
9/3/2018
Question from
Chris Lemon
I just bought a pair of Black Crows Atris (108mm waist), and I have a pair of Dynafit Radical FT 2.0 bindings with a 135mm brake. I noticed on your site that you brakes for the Radical 2.0 and the Radical FT...which one of these brakes i will fit my bindings?
Hey Chris! Sorry for the confusion there, but I'd go for the Radical 2.0 brakes for sure. The Radical FT is referring to the previous generation Radical binding which is very different in all kinds of ways from the Radical 2.0.
Answer this question:
7/7/2018
Question from
Owen
An anti-friction plate on one of my 110mm Radical ST bindings no longer slides properly. Can I fix this by swapping a working friction plate in from a new brake?
Hey Owen! That could definitely work, though is probably the most expensive way to solve the issue (unless you need parts from another brake anyways). I would keep an eye on our Dynafit Binding Parts listing because usually we are stocking those spare parts though it looks like we are out at the moment. If not there then keep an eye on our Used Dynafit Parts listing as well.
Answer this question:
5/26/2018
Question from
Ben
Hi. Is there any way to get a 130mm brake into the new tltspeed? I see they make them that big for the rotation.
Hi Ben, unfortunately not. 105mm is the widest brake for that family of bindings.
Answer this question:
4/18/2018
Question from
Hilary
I would like to replace my Dynafit Beast bindings that have 105 brakes on my 105 width skis. If I buy Dynafit TLT Radical ST 2.0 Bindings, can the Beast brakes be installed with them? Thank you.
Hi Hilary, Radical and Beast brakes aren't compatible. Best bet is to get a 105mm brake with the new binding. Since Radical 2.0 stock has pretty much dried up in that size, I'd look at getting the successor binding, the ST Rotation.
Answer this question:
3/28/2018
Question from
Bill
I have a pair of Dynafit Radical FT 2 with 105 brakes. Will that brake work on a ski that is 88 underfoot (the BD Helio 88). If not, what is involved is swapping out the brakes? Or do I just need to buy a new binding? Many thanks in advance.
Bill- 105 brake width will work but you might catch the shoulders while skinning. The 90mm is the better choice. You need to remove the binding from the ski (if mounted). Then remove the heel piece from the base plate (not hard) and swap heel to the new base plate/brake.
Answer this question:
3/23/2018
Question from
Matt
Hi, I have a pair of the TLT Speed Bindings that I would like to mount on a pair of Dynafit Chugach skis. Are there any Dynafit Brakes that will work for this set-up? Thanks
Hey Matt. Tough to say for sure as Dynafit has a handful of bindings called the TLT Speed. Would you mind sending us a picture of the binding so we can eliminate any potential confusion?